The Blog

Small Engine Service Estimate Aurora

Best Snowblower Engine Repair Aurora!

Standing in your driveway at 7 A.M. with a foot of snow on the ground, and a wind chill below zero, is the last place you want to finally figure out how to start your new snow blower.

So here’s an easy cheat sheet to help you get your snow blower fired up when you need it most.

Best Snowblower Engine Repair Aurora!

Pre-start Checkup:

Oil level is at the full mark
Drive control lever is set to Neutral (N)
Fresh fuel is in the tank

Best Snowblower Engine Repair Aurora
Best Snowblower Engine Repair Aurora

* Best Snowblower Engine Repair Aurora – Starting steps and order of procedure may slightly differ depending on the snow blower or engine manufacturer. Refer to your owner’s manual for detailed starting instructions specific to your model.

1.) Set the Choke to FULL
Set the Choke to Full

Best Snowblower Engine Repair Aurora – FULL Choke means the choke is closed. This seals off the carburetor’s air supply in order to create a richer fuel mixture needed to start a cold engine. Move the choke back to RUN once the engine warms up.

Best Snowblower Engine Repair Aurora!

2.) Move the Throttle to the FAST Position (rabbit symbol)
Move the Throttle to Fast Position (rabbit symbol)
Always operate your snow blower with the throttle set in the FAST position.

3.) Open the Fuel Shutoff Valve

The fuel shutoff valve opens and closes the fuel line leading from the fuel tank to the carburetor. Open or set the valve in the ON position to start. When the snow blower is not running, close the fuel shutoff valve to reduce any chance of leakage.

Best Snowblower Engine Repair Aurora
Best Snowblower Engine Repair Aurora

4.) Flip the Ignition Switch to RUN

The ignition switch, sometimes referred to as the rocker switch, engages the ignition system. Set the switch to RUN when starting, and back to STOP when not in use.

5.) Insert the Safety Ignition Key

The small plastic or metal ignition key for your snow blower is an important safety device. Removing the key while your snow blower is running will shut down the engine, in case you need to quickly stop for an emergency.

Insert the key until it snaps into place. Some snow blower engines do not require a key, only an ignition switch.

6.) Press Primer Bulb

Pressing the primer bulb pumps a small amount of fuel into the carburetor. Depending on your manufacturer’s recommendations, pressing the primer 2-3 times is sufficient enough to help start a cold engine.

7.) Pull Starter Rope – Snow Blower Pull Starter Rope

Slightly pull the starter rope until you feel the recoil engage, then firmly and quickly pull the rope to start the engine.

Electric Start Option
For snow blowers equipped with a 120V electric start option, first repeat steps 1-6.

Plug in the Power Cord
Plug a 3-wire extension cord into the electric start adapter on the snow blower. Plug the other end of the power cord into a convenient 120V outlet.

Best Snowblower Engine Repair Aurora
Best Snowblower Engine Repair Aurora

Press the Red Start Button – Snow Blower Electric Start Button

Push the red button until the engine starts. Release the button after the engine has fully started. Finally, disconnect the power cord from the outlet and engine.

Don’t Forget the CHOKE
Remember to move the choke to the OFF or RUN position once the engine has warmed up.

If you have any comments or questions, feel free to email us at articles@snowblowersatjacks.com.
Article by: Snowblower Repair in Aurora CO

Best Snowblower Repair Cheap Aurora CO – 720.298.6397Best Affordable Snowblower Repair Aurora CO – 720-298-6397Best Snowblower Drive Repair Aurora CO – 720.298.6397Best Snowblower Repair Cheap Aurora COBest Snowblower Repair Shop Near Me Aurora CO

Best Snowblower Engine Repair Aurora
  • Repairs
  • Services
  • Maintenance
  • Tune Ups
  • Costs
  • Prices
  • Estimates
  • Quotes
  • In Home Services
4.7

Summary

Ronnie came out the day after calling, and got my snowblower working in tip top condition, in an hour.. Very courteous, explaining what he was doing, and walked me through how to maintain it better. I was definitely impressed.

Sending
User Review
0 (0 votes)

Leave a Comment

Your email address will not be published.

Your Comment*

Name*

Email*

Website


Important This site makes use of cookies which may contain tracking information about visitors. By continuing to browse this site you agree to our use of cookies.